- edited description
Cables stop conducting once a certain length is reached.
Issue #1
resolved
Transmission loss: Works partially. Straight line, source to sink with no voltage change, works just fine. However, when the loss is too big. Cable lengths that would yield a loss >= 10 EU/t simply dont transfer energy. (http://puu.sh/iE29w/fd513c926c.jpg) Too many curves on the cables results in the same problem above (no energy transmitted), even if the cable is not long enough to cause the problem mentioned above. (http://puu.sh/iE2mK/a186d6fb73.jpg)
(Original Bug Report by SpwnX)
Comments (3)
-
reporter -
reporter -
assigned issue to
-
assigned issue to
-
- changed status to resolved
Fixed... Was my derp bug... Done at least 321f60e
- Log in to comment