Question: Custom horizon map: Loop and Utility condition

[Ruediger]

Hi Stefan,

I have tested the custom horizon map based on my actual measured horizon points and it works quite nicely for planning.
But I have three questions:

1. does the loop condition “Loop while Altitude above Horizon” use the custom map or standard horizon?
2. will there be a condition “loop while Object visible in custom field of view”
3. will there be a Utility condition “wait until object gets into custom field of view.

Thank you!

Rüdiger

‌

[Stefan B]

1. Yes of course it will use the custom horizon if specified (or 0 altitude when none is specified)
2. Not sure I understand this point
3. There already is “Wait until above Horizon” which will use the custom horizon if specified (or 0 altitude when none is specified)

‌

[Ruediger]

Thanks for clarifying. I will test it. Great feature.

The second question was not too well considered. I was thinking of the situation, that one direction is completely blocked. But after re-thinking I noticed that this situation can also be described via ALT values = 90. So all is fine.

‌

[Ruediger]

Topic clarified.

[Stefan B]

Removing version: 1.11 Nightly (automated comment)