Creating template ergonomic suggestion
In the sequencer, I notice that you can save an instruction set from the middle section as a template, but you cannot from either of the start or end sections. There is a workaround, by dragging those sets into the middle and then saving them. An ergonomic nicety rather than a necessity.
Comments (7)
-
repo owner -
reporter how strange, I just tried it in the latest beta and it did not have the save as template icon … only when you drag it to the center
-
repo owner Can you post a screenshot?
-
reporter Sure thing, I will - but it will be tomorrow now, just going to bed.
-
reporter Hello Stefan - how utterly bizarre. It is working now. Maybe it was because I had created the sequence with an old beta. Sorry to trouble you. If I see it again, I will screen grab it for sure (as I should have done last time). Stay Safe
-
repo owner - changed status to closed
Ok good that it is working for you now! I will close the issue, but if the problem arises again feel free to reopen it.
-
repo owner - removed version
Removing version: 1.11 Nightly (automated comment)
- Log in to comment
Saving an instruction set in the start and end areas as templates should be possible. I just tried it out and that works.