Nightly 93: Advanced Sequnce - Switch commands are not properly loaded when UPBv2 is already connected

[Ruediger]

Hello,

when the the sequence contains commands for switching USB and/or power outputs, they are not properly loaded when the box is already connected. Instead of the dedicated ports they are all reverted to port / USB “Output #1”. Please see screen shot.

But if the UPBv2 gets connected after the sequence was loaded then suddenly the ports are switched to the correct ones. Also disconnecting and reconnecting of the UPBv2 fixes the problem.
This is reproduceable. Log attached. It contains some error.

Thank you
Rüdiger

‌

‌

[Stefan B]

Hi,

does this happen when a sequence is loaded via template, target or a complete sequence is reloaded in?

[Ruediger]

When the complete sequence is (re-)loaded:

‌

[Stefan B]

Fix Issue #885 - Advanced Sequnce - Switch commands are not properly loaded when UPBv2 is already connected

→ <<cset efcb85adb6c9>>

[Stefan B]

I think i've found the issue and nightly 94 will fix it.

[Ruediger]

Thanks! I will test as soon as 94 is available.

Rüdiger

‌

[Ruediger]

Test result: of 94:

• When UPB is connected and sequnce is loaded, now the names are set correctly.
• Only if not connected, they are generic. But I think this correct, since the switchport are undefined at this moment.

So I can confirm the fix is working.

Thank you!
Rüdiger

‌

‌

[Stefan B]

Removing version: 1.11 Nightly (automated comment)