hp pavillion dv9000's webcam not supported.

~/r5u87x$ ./loader Searching for device...

Error: Failed to find any supported webcams.

hp pavillion dv9000

~/r5u87x$ lsusb Bus 005 Device 002: ID 05ca:1870 Ricoh Co., Ltd Webcam 1000 Bus 005 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub Bus 004 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub Bus 003 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub Bus 002 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub Bus 001 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub

~/r5u87x$ uname -a Linux starlight-03 2.6.27-7-generic #1 SMP Thu Oct 30 04:12:22 UTC 2008 x86_64 GNU/Linux

Check out the bottom of loader.h, and uncomment as appropriate to your machine. Ideally, we don't have to get you to uncomment it - we'd just detect it - but that the moment we don't have the code to do that.

I'll mark this as open so I'll get around to it later.

Issue #29 was marked as a duplicate of this issue.

Issue #33 was marked as a duplicate of this issue.

HP dv6000 same problem. When I run ./loader, I get the error below that no supported devices are present.

samcompton@ELVIS:/DATA/LinuxDrivers/r5u87x-881dbd07a263$ ./loader r5u87x firmware loader v0.1 Searching for device...

Error: Failed to find any supported webcams.

Here is my lsusb output:

samcompton@ELVIS:/DATA/LinuxDrivers/r5u87x-881dbd07a263$ lsusb Bus 005 Device 002: ID 05ca:1870 Ricoh Co., Ltd Webcam 1000 Bus 005 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub Bus 004 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub Bus 003 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub Bus 002 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub Bus 001 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub

I tried uncommenting these lines in loader.h but, still no luck.

{ 0x05CA, 0x1870, 0x0100 }, Used for HP Webcam 1000 (1870_1.fw) { 0x05CA, 0x1870, 0x0112 }, Used for HP Pavilion dv1xxxx (1870.fw)

Did you recompile after uncommenting?

Yes. I ran Make again. It said there was nothing to be done.

Thanks for the suggestion.

Same here. I have a HP dv6xxx with a "05ca:1870 Ricoh Co., Ltd Webcam 1000" running Ubuntu 8.10 (kernel 2.6.27-9-generic). I tried uncommenting the line at the end of loader.h and then I recompiled the whole thing using this commands:

~$ cc -g -Wall -DHAVE_CONFIG_H  `pkg-config --cflags glib-2.0 libusb` -c loader.c loader.h
~$ cc -g -Wall  -o loader loader.o `pkg-config --libs glib-2.0 libusb`

but still, it doesn't matter if I run the loader file with or without sudo. It says it failed to find any supported webcams. Any more ideas?

1. edit loader.h 2. make clean 3. make 4. ./loader

Under the new kernel this didn't work but I'm pretty sure it worked before, I think it's due to uvcvideo being messed up and not this driver.

So, it detects it OK? ./loader --reload doesn't help? Does dmesg give any useful information and/or debug output from the application you're trying to test with?

1. edit loader.h 2. make clean 3. make 4. ./loader run ; the firmware is uploaded ./loader --reload works too. 5. the webcam is not detected by Ekiga nor xsane, nor Skype The file /dev/video0 is missing. If it's the reason why, how to create it.

I got this after uncommenting those lines and compiling again.

	sudo ./loader
r5u87x firmware loader v0.2

Searching for device...
Found camera: 05ca:1870
Warning: Failed to get microcode status.

Error: Failed to upload firmware to device: Connection timed out (code -110).

kernel is 2.6.27-9 and webcam is Bus 005 Device 002: ID 05ca:1870 Ricoh Co., Ltd Webcam 1000 on hp pavilion dv9000 running Kubuntu 8.10.

Any help is appreciated.

HP DV9000t, Suse linux 11.1/KDE 4.2, kernel 2.6.27.7-9-default.

Webcam is: Bus 005 Device 003: ID 05ca:1870 Ricoh Co., Ltd Webcam 1000 (from lsusb)

1. Uncomment * { 0x05CA, 0x1870, 0x0112 }, Used for HP Pavilion dv1xxxx (1870.fw) in loader.h 2. make clean 3. make 4. JUDAS-KDE42:/home/enj/bin/r5u87x # make rules 5. JUDAS-KDE42:/home/enj/bin/r5u87x # make install 6. JUDAS-KDE42:/home/enj/bin/r5u87x # r5u87x-loader r5u87x firmware loader v0.2

Searching for device... Found camera: 05ca:1870 Camera reports positive microcode state. Camera reports microcode version 0x0112. Not doing anything - camera already setup.

Successfully uploaded firmware to device 05ca:1870!

Still no camera detected by skype or kopete and no /dev/video0 Same thing using --reload switch.

Please let me know if there is anything else I can try to get this working!

Thanks!

[e-mail]

Any luck for the Bus 002 Device 003: ID 05ca:1812 Ricoh Co., Ltd. My HP Pavilion dv9750ep use it. I already tried the last version of your driver, the 0.2.0. But still no luck.

Any luck for the 05ca:1812 ? My HP Pavilion dv9750ep have one. I already tried the last version of your driver, the 0.2.0. But still no luck. But with mplayer -fps 15 tv://

I can see myself on the webcam. But on amsn it hang on and in kopete too. I use slackware 12.2 The drive for 05ca:1812 is still on development? Or someone have this working already with amsn and other software? Plz send me news about it.

I uncommented the right line in loader.h but no luck, here is what i get:

$ sudo ./loader r5u87x firmware loader v0.2

Searching for device... Found camera: 05ca:1870 Warning: Failed to get microcode status.

Error: Failed to upload firmware to device: Connection timed out (code -110).

I have the same issue as above...

$ sudo r5u87x-loader

r5u87x firmware loader v0.2

Searching for device... Found camera: 05ca:1870 Warning: Failed to get microcode status.

Error: Failed to upload firmware to device: Connection timed out (code -110).

Same as the previous couple reports, uncommented the corresponding line but get no love from the loader. The dmesg output is:

r5u87x$ dmesg | grep r5 [ 18.933929] usbcam: registering driver r5u870 0.11.2 [ 18.942621] r5u870: Found DMI model: "HP Pavilion dv9000 (EZ452UA#ABA) " [ 18.942627] r5u870-0: Detected HP Pavilion Webcam (WDM) [ 18.942726] firmware: requesting r5u870_1870.fw [ 20.143961] r5u870-0: Microcode file "r5u870_1870.fw" is missing [ 20.143970] r5u870-0: Please see http://wiki.mediati.org/r5u870/Microcode [ 20.143974] r5u870-0: initialization failed: -2 [ 20.143990] r5u870: probe of 2-4:1.0 failed with error -2 [ 20.144035] usbcore: registered new interface driver r5u870 [ 2998.728204] usb 2-4: usbfs: USBDEVFS_CONTROL failed cmd r5u87x-loader rqt 192 rq 164 len 1 ret -110 [ 3067.032209] usb 2-4: usbfs: USBDEVFS_CONTROL failed cmd r5u87x-loader rqt 192 rq 164 len 1 ret -110 [ 3077.289216] usb 2-4: usbfs: USBDEVFS_CONTROL failed cmd r5u87x-loader rqt 192 rq 164 len 1 ret -110 [ 3148.812213] usb 2-4: usbfs: USBDEVFS_CONTROL failed cmd r5u87x-loader rqt 192 rq 164 len 1 ret -110 [ 3154.200209] usb 2-4: usbfs: USBDEVFS_CONTROL failed cmd r5u87x-loader rqt 192 rq 164 len 1 ret -110 [ 3449.941207] usb 2-4: usbfs: USBDEVFS_CONTROL failed cmd r5u87x-loader rqt 192 rq 164 len 1 ret -110

Output from lsusb: says:

Bus 002 Device 002: ID 05ca:1870 Ricoh Co., Ltd Webcam 1000

I'm running on Ubuntu 8.10 2.6.27-11-generic #1 SMP Wed Apr 1 20:57:48 UTC 2009 i686 GNU/Linux. Any help is greatly appreciated.

HP Webcam 1000 Not Working

I'm running Ubuntu 9.04 on a HP pavillion dv9000 and trying to get the webcam to work. Here's what I've done so far:

1. lsusb gives: Bus 001 Device 002: ID 05ca:1870 Ricoh Co., Ltd Webcam 1000
2. uncommented from loader.h: { 0x05CA, 0x1870, 0x0100 }, Used for HP Webcam 1000 (1870_1.fw)
3. ran these commands: make clean, make, make rules, sudo make install, sudo ./loader
4. Here's the output when I run loader:

r5u87x firmware loader v0.2

Searching for device... Found camera: 05ca:1870 Warning: Failed to get microcode status.

Error: Failed to upload firmware to device: Connection timed out (code -110).

Thanks for any help.

exactly as the last couple of posts, same steps, ends with code -110..

What to do???

Hey,

Thanks for your work! It isn't working, but at least I got a different error message :-) Here's what I did:

- # lsusb gives: Bus 001 Device 002: ID 05ca:1870 Ricoh Co., Ltd Webcam 1000 - # uncommented from loader.h: { 0x05CA, 0x1870, 0x0100 }, Used for HP Webcam 1000 (1870_1.fw) - # ran these commands: make clean, make, loader: output was: r5u87x firmware loader v0.2

Searching for device... Found camera: 05ca:1870 Camera reports negative microcode state. Sending microcode to camera... Enabled microcode. Camera reports microcode version 0x0112. Warning: Camera returned unexpected ucode version 0x0112 - expected 0x0100

Error: Failed to upload firmware to device: Inappropriate ioctl for device (code -74).

Bump!

Bump!

Hi

I have also got this error for my Ricoh webcam 1000 for Hp Pavillion dv6000 laptop...

sudo ./loader r5u87x firmware loader v0.2

Searching for device... Found camera: 05ca:1870 Camera reports negative microcode state. Sending microcode to camera... Enabled microcode. Camera reports microcode version 0x0112. Warning: Camera returned unexpected ucode version 0x0112 - expected 0x0100

Error: Failed to upload firmware to device: Inappropriate ioctl for device (code -74).

Bump!

Bump!

Hi

I was getting this error before for my Ricoh webcam 1000 for Hp Pavillion dv6000 laptop...

sudo ./loader r5u87x firmware loader v0.2

Searching for device... Found camera: 05ca:1870 Camera reports negative microcode state. Sending microcode to camera... Enabled microcode. Camera reports microcode version 0x0112. Warning: Camera returned unexpected ucode version 0x0112 - expected 0x0100

Error: Failed to upload firmware to device: Inappropriate ioctl for device (code -74).**

Then I went to user and groups and set my user to video priviledges(earlier it was disabled).

After doing that I am facing this error now:

$sudo ./loader r5u87x firmware loader v0.2 r5u87x firmware loader v0.2

Searching for device... Found camera: 05ca:1870 Warning: Failed to get microcode status.

Error: Failed to upload firmware to device: Connection timed out (code -110).**

Regards Sac

Still not working! Do you have suggestions?

I think that you have to remove support to this device if it still doesn't work!

Hi folks, I'm trying to get my webcam 05ca:1812 working.

I get this error:

sudo r5u87x-loader --reload r5u87x firmware loader v0.2

Searching for device...

Error: Failed to find any supported webcams.

This issue was already mentioned here: https://bitbucket.org/ahixon/r5u87x/issue/33/not-working-with-hp-pavillion-webcam-bus And above it's said, that this is an dublicate of the issue here.

BUT, if I try to uncomment a line in loader.h, I find the following:

static const struct device_info device_table[] = { { 0x05CA, 0x1803, 0xFFFF, 0, 0 }, Unknown ucode version. { 0x05CA, 0x1810, 0x0115, 0, 0 }, /* 05ca:1812 does not require ucode. */ { 0x05CA, 0x1830, 0x0100, 0, 0 }, { 0x05CA, 0x1832, 0x0100, 0, 0 },

What does this actually mean? How do I get my webcam 05ca:1812 working?