Timer wakeup from Shutdown should go to Standby mode
Issue #107
resolved
When a timer cause the unit to wakeup from the Shutdown state it currently goes to fully on state it should go to Standby state.
Going to fully on can cause issues with triggering smart input selection on AV receivers, etc ...
This may need changes to the Micom front panel firmware to distinguish user power on versus timer event wakeup.
Reproduction steps
- Set a record timer.
- Put the unit in fully Shutdown state.
- When timer is due unit boot to fully on state, it should only go to Standby state.
Comments (7)
-
reporter
-
reporter
- removed issue_depends
Bug report 114 now depends on the solution of this Feature request
-
reporter
- removed issue_issuetype
Thinking about this some more, I think it is actually a bug and have changed it from a Feature request to a Bug.
It is associated with a raft of other issues to do with timer wakeup and shut down afterwards not working as expected.
-
reporter
- removed issue_issuetype
The issue was updated with the following change(s):
- The issue type has been updated, from Feature request to Bug report.
-
reporter
- removed issue_reproducability
The issue was updated with the following change(s):
- This issue's reproduction steps has been changed
-
- removed issue_category
The issue was updated with the following change(s):
- The category has been updated, from Not determined to Application / User Interface.
-
- changed status to resolved
This should be fixed in 20150128
- Log in to comment
Probably very related is the power management timer "Wakeup to Standby" also does a fully on Wakeup.
As for "triggering smart input selection on AV receivers" we are probably screwed here as the boot loader turns on the video out.