Skip the network configuration screen in setup wizard

[Peter Urbanec]

In setup wizard skip the network configuration screen with "Use interface" and "Use DHCP" options.

Instead, detect whether a LAN cable is inserted, if not, tell the user that the network cable is not connected and the network will not be active. Suggest that they can configure networking later, from the Setup menu. If a LAN cable is detected, obtain settings via DHCP and show the results. If DHCP fails, let user specify settings manually.

The idea here is that in a typical home network scenario, just plugging the LAN cable into the box will work without having to press too many buttons.

[prl]

The issue was updated with the following change(s):

• The issue's poster has been changed, from prl to peteru.

[prl]

The issue was updated with the following change(s):

• The status has been updated, from New to Confirmed.

[Peter Urbanec]

The issue was updated with the following change(s):

• The status has been updated, from Confirmed to Delegated.

[Peter Urbanec]

The issue was updated with the following change(s):

• The category has been updated, from Not determined to Application / User Interface.