- removed issue_status
Factory reset does not clear network interface activation state
Issue #117
resolved
Resetting to factory defaults does not re-enable the LAN interface if it has been previously disabled by the user.
Reproduction steps
- Setup / Network / Network Interface - set LAN interface to NOT use interface
- Setup / System / Factory reset
- When the wizard gets to the network configuration stage, the default for the LAN interface is disabled
Comments (5)
-
-
reporter - removed issue_status
The issue was updated with the following change(s):
- The status has been updated, from Confirmed to Delegated.
-
reporter - removed issue_priority
The issue was updated with the following change(s):
- The priority has been updated, from Normal to High.
-
reporter - removed issue_status
The issue was updated with the following change(s):
- The status has been updated, from Delegated to Testing.
-
reporter - removed issue_resolution
- removed issue_percent
- removed issue_close
- removed issue_status
The issue was updated with the following change(s):
- The status has been updated, from Testing to Closed.
- This issue has been closed
- This issue's progression has been updated to 100 percent completed.
- The resolution has been updated, from Not determined to Fixed.
- Log in to comment
The issue was updated with the following change(s):