- removed issue_status
Scanning on USB tuner uses default location, not configured location
In MENU>Setup>Antenna Setup>Automatic Scan and with the firmware's own terrestrial.xml, if you scan with only Tuner A, it scans the configured location (Canberra for me). However, if you scan with only tuner D, it scans with the default location (Sydney). If you scan with both tuners, it scans the configured location and then scans the default location.
The difference between a scan of Canberra and a scan of Sydney in Canberra is that the Sydney scan won't find the ABC channel, but will find all the others. Hence the missing ABC services.
I have confirmed this by loading an alphabetically-ordered terrestrial.xml, and when I do that, the scan with tuner D scans Adelaide when the location is set to Canberra.
If your Location is set to Sydney, you won't see this problem.
Reproduction steps
To reproduce, Factory Reset and scan with a location other than Sydney using the firmware's own terrestrial.xml. Then go to MENU>Setup>Antenna Setup>Automatic Scan, disable tuner A and scan. Make a note of the frequencies actually scanned. Compare thos frequencies with the terrestrial.xml frequencies for the location set in the Factory Reset, and with the frequencies for Sydney.
Comments (3)
-
-
- removed issue_status
The issue was updated with the following change(s):
- The status has been updated, from Delegated to Testing.
-
reporter - removed issue_resolution
- removed issue_percent
- removed issue_close
- removed issue_status
The issue was updated with the following change(s):
- The status has been updated, from Testing to Closed.
- This issue has been closed
- This issue's progression has been updated to 100 percent completed.
- The resolution has been updated, from Not determined to Fixed.
- Log in to comment
The issue was updated with the following change(s):