Scanning on both internal and USB tuner sometimes crashes
In MENU>Setup>Antenna Setup>Automatic Scan, if both Tuner A and Tuner D are enabled for the scan, the scan sometimes crashes between the end of pass 1 (Tuner A) and the start of pass 2 (Tuner D).
Crash log attached.
Reproduction steps
Go to MENU>Setup>Antenna Setup>Automatic Scan, and start scan. Leave both tuners enabled for the scan and set Clear before scan to 'yes' (default settings). Start scan. If the crash happens it will be after pass 1 ends and before pass 2 starts.
You may need to repeat this several times. The attached crash log happened on the third auto scan after a firmware upgrade (and normal scan in the setup wizard).
The attached crash log happened on the third scan attempt.
Comments (9)
-
reporter -
- removed issue_status
The issue was updated with the following change(s):
- The status has been updated, from New to Delegated.
-
- removed issue_status
The issue was updated with the following change(s):
- The status has been updated, from Delegated to Testing.
-
reporter -
reporter - removed issue_status
Listed as fixed in the change log for 20140316. Not fixed, crash log from firmware 20140316.
Seems even worse in firmware 20140317, and has crashed every time I tried to scan with tuners A and D both enabled.
The issue was updated with the following change(s):
- The status has been updated, from Testing to Not Fixed.
-
- removed issue_status
The issue was updated with the following change(s):
- The status has been updated, from Not Fixed to Testing.
-
- removed issue_category
The issue was updated with the following change(s):
- The category has been updated, from Not determined to Driver / Hardware.
-
- removed issue_severity
The issue was updated with the following change(s):
- The severity has been updated, from Major to CRASH.
-
- removed issue_resolution
- removed issue_percent
- removed issue_close
- removed issue_status
The issue was updated with the following change(s):
- The status has been updated, from Testing to Closed.
- This issue has been closed
- This issue's progression has been updated to 100 percent completed.
- The resolution has been updated, from Not determined to Fixed.
- Log in to comment
A file was uploaded. reference to attachment enigma2_crash_1394956207.log (T3 crash log)