Welcome Wizard initial option message confusing
When the T3 first starts and there is an existing configuration backup there is an initial restore screen presented by the Welcome Wizard. The two options listed for the question "Do you want to restore your settings?" are "Yes, restore the settings now >" and "No, just start my receiver >".
Point 1: The second option suggests that selecting this option will take you directly to using the unit. This is not what happens. Taking this option continues the wizard and steps you through configuring the T3. The option would be better worded as "No, continue with the initial set up" or something to this effect.
Point 2: The two options have the ">" indicator at the end of the line that suggest that these options lead to a sub menu. This is NOT the case. The ">" symbols should be removed unless there is a sub menu attached to the menu selection.
Reproduction steps
This screen is seen immediately after a firmware update IF there is an existing backup of previous settings.
Comments (5)
-
reporter -
reporter - removed issue_update
The issue was updated with the following change(s):
- This issue's description has been changed
-
- removed issue_status
The issue was updated with the following change(s):
- The status has been updated, from New to Confirmed.
-
- removed issue_status
The issue was updated with the following change(s):
- The status has been updated, from Confirmed to Testing.
-
- removed issue_resolution
- removed issue_percent
- removed issue_close
- removed issue_status
Point 2, i.e. the trailing ">" symbols are all over the UI. This should be fixed globally.
The issue was updated with the following change(s):
- The status has been updated, from Testing to Closed.
- This issue has been closed
- This issue's progression has been updated to 100 percent completed.
- The resolution has been updated, from Not determined to Fixed.
- Log in to comment
A file was uploaded. reference to attachment WelcomeRestore.jpg (Welcome Wizard first screen if a backup exists.)