- removed issue_priority
Add user level all tuner diagnostic screen
As suggested in a post by Raid there needs to be user screen that presents the status of all 4 tuners, i.e. channel, frequency, power, s/n, ber, etc.
Controls on the screen should allow you to choose a tuner and cycle through the all the LCN's, including the radio LCN's. The picture of that tuner should be displayed as a 1/4 screen pip style image top right of the screen.
When selecting an LCN that another tuner has already tuned that transponder frequency the transponder frequencies should be swapped between the 2 tuners. Thus allowing all transponder frequencies on all tuners to be eventually tested.
If a recording is to be effected by the operation a warning should be displayed with the options to stop the recording or not do the operation.
Comments (6)
-
-
- removed issue_status
The issue was updated with the following change(s):
- The status has been updated, from New to Confirmed.
-
- removed issue_priority
The issue was updated with the following change(s):
- The priority has been updated, from Low to High.
-
- removed issue_priority
Given the issues with tuners being experienced in the field a diagnostic tool of this calibre is highly desirable and should not be considered a low priority.
-
- removed issue_category
The issue was updated with the following change(s):
- The category has been updated, from Not determined to Application / User Interface.
-
- marked as minor
- edited description
- Log in to comment
The issue was updated with the following change(s):