Recording timers set from OpenWebif have wrong default recording location

[prl]

When a recording timer is set from the OpenWebif interface, the user is offered "Default" or "/media/hdd/hdd/movie". If "Default is used (it's also the default in OpenWebif), te timer on the T3 is created with its Recording location set to None, and the timer fails to record.

The "Default" location in OpenWebif should use MENU>Settings>TV>Recording settings>Timer recording location, and if that is set to default to Default movie location, then Default movie location should be used.

The problem can be worked around by explicitly choosing the recording location when setting up the timer from OpenWebif, but the "Default" setting should reflect the T3's recording default.

Reproduction steps

In OpenWebif, click on TV Multi EPG. Then click on a future event and then click on the clock icon in the popup to open the timer creation popup. Leave the Location as "Default", and then click on Save.

Then with the T3 remote, press TIMER, navigate to the timer set from OpenWebif, and press OK to open the timer for editing. The Recording location will be None. Cancel the edit with RED Cancel, and allow the timer to run. It will fail because there is no recording location set.

[prl]

The issue was updated with the following change(s):

• This issue's title has been changed

[prl]

The issue was updated with the following change(s):

• The status has been updated, from New to Closed.
• This issue has been closed
• This issue's progression has been updated to 100 percent completed.
• The resolution has been updated, from Not determined to Fixed.