- removed issue_status
Show tuned frequencies to 3 decimal places
Tuner frequencies are displayed in the GUI to zero or one decimal place. They should be shown to three places (i.e. 205.625MHz rather than 205MHz or 205.6MHz). Possible tuning frequencies in Australia are xxx.500MHz, xxx.375MHz and xxx.625MHz.
For example, the tuner frequency is shown to zero decimal places MENU>Setup>Information>Service YELLOW Multiplex and BLUE Tuner Status, and to one place in in the Auto scan.
Comments (7)
-
-
- removed issue_priority
The issue was updated with the following change(s):
- The priority has been updated, from Normal to High.
-
- removed issue_severity
The issue was updated with the following change(s):
- The severity has been updated, from Not determined to Minor.
-
A file was uploaded. reference to attachment BBB_56.patch (Proposed patch to fix this issue.) This comment was attached:
Proposed patch to fix this issue.
A Bitbucket pull request has also been generated for branch peteru/master
-
- removed issue_status
The issue was updated with the following change(s):
- The status has been updated, from Confirmed to Testing.
-
Most important, especially during early testing where it is vital to be able to see exactly what the tuning setup did. Particularly with the 125KHz offset stuff in play.
-
- removed issue_resolution
- removed issue_percent
- removed issue_close
- removed issue_status
Frequency display to 3 decimal places in both screens.
The issue was updated with the following change(s):
- The status has been updated, from Testing to Closed.
- This issue has been closed
- This issue's progression has been updated to 100 percent completed.
- The resolution has been updated, from Not determined to Fixed.
- Log in to comment
The issue was updated with the following change(s):