- removed issue_status
The optical SPDIF output seems to be active even in standby
The optical SPDIF output seems to be active even in standby. You can tell because there is red light being emitted at all times, visible either directly from the back, reflected onto a wall behind the PVR or even visible through the ventilation holes in the top of the case.
Reproduction steps
Set T3 to Standby, look at SPDIF socket.
Comments (5)
-
-
- removed issue_posted
The issue was updated with the following change(s):
- The issue's poster has been changed, from prl to peteru.
-
Yes bad form to turn off the video outputs but leave the SPDIF alive.
May not be possible to turn this off, so a fallback should nuke the data stream. Failing that option then just mute the audio stream.
Also need to test the analogue audio output during standby. Of course it should be silent.
-
reporter Ian Brabham wrote:
Also need to test the analogue audio output during standby. Of course it should be silent.
It is.
-
reporter - removed issue_resolution
- removed issue_close
- removed issue_status
This is a hardware limitation. Apparently even though the SPDIF LED is on, there is no data being output.
The issue was updated with the following change(s):
- The status has been updated, from Confirmed to Rejected.
- This issue has been closed
- The resolution has been updated, from Not determined to CAN NOT FIX.
- Log in to comment
The issue was updated with the following change(s):