"0C" appearing on the display periodically for very short period
Issue #119
resolved
A couple times per minute I’ll see “0C” appear on the display for a very short time.
Connected to an ASI BAC800, motor temp reads OK in ASI Bacdoor app (18C or so right now). And speed, amps, etc all read OK from the controller on the display.
Display FW is 2_14_19 Beta.
Comments (4)
-
-
reporter Thanks, so it is supposed to be motor temp. Odd that I’m not getting a reading on it.
-
Have the same problem with ASI bac and eggrider V2 the temperature flashes very short it shows only 0C.
-
- changed status to resolved
this should be fixed with fw v2.5.23
- Log in to comment
In that same spot is motor temp. At least in KT protocol. I don’t know why ASI don’t show temp properly. I had motor temp +79c when i take this picture.