Assist level type not work (Kuteng controller)
When i setup assist level type to 0- [0-9] and max level road 5 it not work, actually when i choose whatever to assist level type it works only 0 - 1 - 3 - 5 - 7 - 9, it wont go just 0-1-2-3-4-5-6-7-8-9 etc, also max level road setting not work
Comments (5)
-
-
reporter Hi, i just tested it, and nope. I choose Indipendent values for both modes, and max level road, 3 and 5, but it goes still up to 9 always. I tested reboot display and app but still the same.
-
reporter Little update: Max level on road mode work. I have to set Level behaviour mode to "Max level road" not "Indipendent values for both modes" and after that when i use road mode assist level not go higher than i set.
But there is still issue at those assist levels. KT systems there is assist levels 1,2,3,4,5 and 0, and currently i cannot choose that kind of option in app. So assist levels goes currently 0,1,3,5,7,9 so there is correct amount those assist levels and they work fine, but that skiping even numbers is kind of funny, and it was much better if they goes 0,1,2,3,4,5 and not skipping numbers like now, because it is confusing sometimes :D
-
reporter This issue is not valid anymore. newest fw update fixed, so it can be mark as solved.
-
- changed status to resolved
Fixed in display firmware v2.1.5
- Log in to comment
Hi. The max level only is active when the type is "Indipendent values for both modes".