Immobilizer not working

[3Dgenesis]

Description:

Immobilizer is enabled in the settings,, all the other options work as intended (so write / read works fine)

Steps to reproduce

After enabling immobilizer and writing to Eggrider I turn off the phone bluetooth, turn off and turn on the Eggrider and I can use throttle.

I have tried a workaround by forcing the Eggrider to boot only in road mode and having all road power levels set to 0%.

That worked but even with this and all values zeroed in ASI menus as well - I can still use the long up button press (walk assist) to throttle the scooter.

Motor/controller model

Motor: stock Inokim Ox single motor.

Controller - ASI BAC855 preprogrammed by ElectricGen shop

App version

App version: 2.6.03

Firmware version

Firmware: 2.6.65

ASI controller version: 6.019

Battery voltage

60v

[Adrian]

Hi there,

Thank you for your message.

To assist you further, could you please provide us with screenshots of all your settings, including the assist level page? This will help us better understand your configuration and provide more accurate support.

We appreciate your cooperation and look forward to your response!

Best regards,
Adrian

‌

[Giacomo C]

This is likely fixed from version 2.7.23 onward