- attached Screenshot_20190204-223807.png
Speed limiter not working on Kunteng Controllers
Dec 14, 2018, 10:49 PM Dear, Ive upgraded the firmware and the new stunning mobile app!! I've got some extra info, I hooked up my throttle to do some tests, with the Eggdisplay the speed limit (Max speed Road/Offroad) setting is still ignored. If i connect the KT-LCD3 display then the speedlimit (set in KT-LCD3) works fine... Hope this can help, i'm sure its just a click less or more...
Jan 5, 2019, 10:06 AM
Dear, i've upgraded the firmware to 2.3.03 but unfortunately this still doesn't give me the working functionality of the speed limit button (Max speed Road/Offroad) setting is still ignored.(If i connect the KT-LCD3 display then the speedlimit (set in KT-LCD3) works fine...)
Comments (8)
-
reporter -
reporter - attached Screenshot_20190204-224358.png
Speed limit for testing placed on 10km/h for "road setting" not reacting on EggRider >>> working on KT-LCD3.
-
I can confirm. I set speed limit to 10km/h for road profile. And it not work. Speed goes above that. I test more tomorrow. This test was made inside using bike stand. However 6km/h throttle mode seems to work fine, or at least it has been worked earlier. I test it tomorrow also. I know that 25km/h limit has been worked at some point, because i remember how i tested it outside and when i change to road mode my bike doesn't go over 25km/h.
I haven't ever tested 10km/h speed earlier so i cannot tell if it worked before or not.
-
reporter Obviously, i did also the test with 25km/h outside without result ... the 10km/h setup i did was to be sure that i would see a significant difference in speed when switching from road to off road profile, but again when putting the KT-LCD3 with speed limit on 10km/h it limits without any issues.
-
reporter Upgraded firmware to eggrider_fw_v2_3_7.zip >>> same result.
-
reporter Upgraded firmware to eggrider_fw_v2_3_8 >>> seems to be working correctly now, great job!!
-
reporter - changed status to resolved
Upgraded firmware to eggrider_fw_v2_3_8 >>> seems to be working correctly now, great job!!
-
- changed version to EggRider V2.3.01 - Android
- Log in to comment
Kunteng settings correspond with KT-LCD3 settings.