Bafang Ultra Ludicrous PAS does not fully disengage

I recently tried adding an Eggrider v2 to a Bafang Ultra from Luna. It has the Ludicrous controller, so not sure if that is fully supported yet by EggRider.

Out of the box an onto the new motor, it seemed to work fine on the first test ride.

The firmware was old so I updated the latest version to get access to the app.

I didn’t change any settings and the next test ride PAS would not disengage without clicking back to Level 0.

PAS would re-engage when I pedal but never fully disengage. It would still provide a constant, small amount of power, like a 6mph cruise control. At any level besides 0 it would continue to push lightly.

I tried two of my other displays, DPC 18 and 750c. The motor disengages with both of those displays and runs properly.

I tried hooking up the Eggrider from my BBSHD, also with current firmware, and it causes the same behavior as the new EggRider, does not disengage.

Could this be a firmware / compatibility issue? I couldn’t find any issues with my settings but can post if needed.

Comments (3)