App crashes at settings

I’ve used Eggrider succesfully without problems for almost a year. After using the display without the app for last two weeks, I now started the app, but it did not start. It said it is not installed. I then removed the app and downloaded the updated version that was updated a week ago at 29.9.19. Then there were connection issues with the display, so I reseted the display to factory defaults. Then I downloaded and installed the Display Firmware v2.4.08. The app is now v2.4.13. I also did the activation with the old code, and it was succesfull. Then restarted everything. Then I checked that versions are still the same, yes should work now, right? I started app, it connects to display easily as before, and says “display settings read succesfully”. But because of reset, the road/offroad mode can now be changed with the mode button, and I wish to change it to only switch from the app. I then press settings-button from the app, and it flashes the messages “motor settings read succesfully” and “pedal settings read succesfully”, then crashes. So I can’t get to the setting to change anything. Could it be because of the new torque-section addition? Also if I press the mode switch on the display, it flashes “switch failed”.

I also reinstalled the firmware and reinstalled the app, and restarted the phone, but same problem persists.

Motor is BAFANG MM G330.250

Comments (5)