Issue #25 resolved

sage-command variable value as void in sage-load.el

Greg Laun
created an issue

I'm not sure whether this issue is specific to my setup, but I've made as good a search into the matter as I can without understanding much about Lisp.

When I get to the (require 'sage "sage") line in my .emacs file, I get an error saying that the symbol sage-command's value as a variable is void. I've traced this error to a line in sage-load.el (line 102 in my sage-load.el) that says

(eval-after-load (quote org-latex) (quote (sage-org-latex-setup)))

A workaround I found is to add a line at the top of sage-load.el that defines sage-command to point to the sage binary.

Also, I'll just add that I've been using sage-mode since .7 and the rate at which issues are being created and fixed these days is amazing. Thanks to everyone working on this right now.

Comments (3)

  1. Ivan Andrus repo owner

    I uploaded a new spkg so that you can test that it was fixed. You can install it with

    sage -f ''
  2. Log in to comment