Static chart overruns when plotting C2 logbook imports from variable interval sessions
I am seeing an anomaly with static chart plots from workouts/sessions I’ve imported from my Concept2 logbook. Basically there appears to be – I’ll call it an overrun or perhaps a runaway – on either a time or a distance static chart plot after session data has been imported, processed and plotted.
The overrun/runaway is at the end (right hand side of the chart) and seems to only happen with session data where I’ve setup up a workout on my PM5 using variable intervals (which I do most of the time). On the occasion where I’ve setup either a fixed single distance or time the chart plots are fine, there are no overruns/runaways.
Attached are some example charts, 30-20-10 Steady State and 30-60 Intervals show the problem on the right – these are from variable interval session setups. The 6k Single Distance was just that, a single distance setup on the PM5, no problem. You are more than welcome to review more of the workload data I’ve imported to Rowsandall if required.
For reference, I’m using a C2 Dynamic with a PM5 f/w V30 and h/w V415.
Kind Regards, Roger
