# UF 1 has been updated in frameData.yaml !!!
/VER=2
/V
/UF=1
/UT=1
#run the flow code stuff
#/RUN flowcode
#set the flow to 50 psi open, 100 psi closed
#/RUN flowset 50 100
#start publishing fake analog values
#/RUN fake_flow_io_publisher
/SP
/J P[1], 200 /Mturnon /TB, 0.5
/L P[2], 200
/L P[3], 200 /Mhamsandwich /TA, 0.3
/J P[1], 200 /Mturnoff /TA, 0.25
/EP

#/UF[1]=P[2]
#/CALL run_fastener(1)
#/DELAY 1000

/POS
# These points 1-3 are relative to the user frame of coupon (UF=1), P1 is the right hand corner of the stringer
#P[1] X=-25.397 Y=76.196, Z=-.035, R=0.000051, P=-.002576, W=.000447
P[1] J1=0, J2=-28.92, J3=518.85, J4=0.0, J5=0.59, J6=-3.39, J7=-33.86, J8=-0.73
P[2] X=-360.36 Y=76.196, Z=-.035, R=0.000051, P=-.002576, W=.000447
P[3] X=-685.797 Y=76.196, Z=-.035, R=0.000051, P=-.002576, W=.000447
P[4] X=550.0, Y=-30.0, Z=45, R=0.0, P=0.0, W=0.0

P[42] J1=0.0, J2=0.0, J3=0.0, J4=0.1, J5=0.0, J6=0.0, J7=0.0, J8=0.0
P[28] X=500.0, Y=-5.0, Z=45.0, R=0.0, P=0.0, W=0.0
P[67] X=500.0, Y=5.0, Z=45.0, R=7.0, P=0.0, W=0.0

P[17] X=407.0, Y=11.0, Z=45, R=0, P=0, W=0