- changed status to resolved
ItsyBitsy 32u4 8MHz 3.3V not allowing config
Issue #205
closed
When connecting this itsybitsy, it will allow me to create the automaton, but when I click configure it just sits there and nothing shows up. I have an Itsybitsy 32u4 16MHz 5V that works fine. Does it need to be the 16MHz 5V variant of the itsybitsy to work? (Version 1.6 (11641))
Comments (2)
-
-
- changed status to closed
- Log in to comment
Yes, if you want to use the firmware in the app. you can also use the source. Here is how to do it:
https://twocanoes.com/knowledge-base/how-to-set-up-arduino-ide-for-mds-automaton/
Or just buy at store.twocanoes.com :)