Error setting precommand delay with Serial
Issue #229
closed
Automaton v21
In Serial when using the command “set_pre_command_delay” it appears that the value is always set to zero. For example, sending:
set_pre_command_delay 20
and then sending:
show
will print:
Pre Command Delay:0
Comments (5)
-
reporter -
- changed status to resolved
fixed in 19076 or later. firmware should be v24 now.
-
reporter - changed status to open
Created automaton and confirmed v24. Still getting same issue for pre_command_delay.
-
reporter - changed status to resolved
-
reporter - changed status to closed
- Log in to comment
Confirmed this is still an issue as of v1.9 build 19075.