Open Firmware password not being entered when using Automaton with PreBeta-MDS_Build-19067_Version-1.9
Issue #238
closed
Hi Tim,
When configuring the Automaton to enter the Open Firmware Password, the password does not seem to stick after click update.
Once I update the configuration, I go back in to make sure my settings are sticking, I notice the password field is blank.
When boot the target Mac with the automaton attached, it does not get past the firmware password screen.
Best regards,
Kamal
Comments (4)
-
-
Tested build 20091 on Mojave and performed as expected. Password is not shown if configure automaton panel is reopened, but automaton did enter firmware password when plugged into target machine.
-
- changed status to resolved
-
- changed status to closed
- Log in to comment
have you had a chanced to check on version 2.0? @Dave Lebbing can you check as well?