Add instruction to connect/disconnect devices

[Jeff S]

Hi,

In a view of full automation would be useful to have instructions like “Connect camera”, “Connect Dome” etc etc as part of startup and end of sequence.

Suppose I’ve a remote setup where the PC is always on and NINA is running. At dusk weather conditions are evaluated and if OK the gears are powered on with an ASCOM Switch. Here devicesmust be connected before running the sequence.

Would be nice to have instructions to connect the ASCOM switch, then switch on some relays to power up the camera, focuser, dome, etc etc, connect them to NINA and the start the imaging session. At the end of the session, disconnect, power off and wait for the next dusk.

Would it be possible to have this automation level?

[Stefan B]

You can use the Connector plugin. It adds instructions to connect and disconnect devices