Crash after setting the gain in a sequence
[x] Is the issue reproducible?
[x] Are you running the latest version?
[x] Are all prerequisites that are mentioned inside the manual met?
Description
It is not possible to insert a gain value into a sequence step created without camera attached to the computer, when using camera simulator. I haven’t checked if the same behavior occurs with a real camera, rather than the simulator.
Steps to Reproduce
- Create a sequence without your camera connected and save it as xml
- Connect the camera simulator
- Load the sequence
- Insert the gain
- NINA will crash
Expected behaviour
No crash but accept the input gain and use it as part of the sequence parameters
Actual behaviour
NINA crashes and closes down
Comments (5)
-
repo owner -
reporter Hi. The version is the latest nightly.
You have created a sequence without any camera connected. Right ? I had two steps in the sequence. The gain tab was not visible.
Then I saved as xml.
Then I closed NINA, because I created the sequence yesterday.
Today, after chatting with people I found out that I could use the camera simulator to make the gain tab appear. So I connected the camera simulator.
In the sequence tab I loaded my sequence.
Now the camera gain tab was there.
I entered the number 100 and NINA crashed.
I did it also a few more times with other numbers. Same behavior.
-
repo owner Which simulator did you use?
edit: ok i see the problem. -
reporter The first camera simulator
-
repo owner - changed status to resolved
Next version won't have this issue.
- Log in to comment
Hi,
i cannot reproduce the problem with the steps you provided. Either they are incomplete or missing information.
Furthermore you did not specify the exact version you’re on. Did you use the latest nightly version of 1.10 or the released 1.9 version?