Release 1.11 NB 32 Warms Camera After Sequence Completes When That Function Is Turned OFF
[Unknown – I was too busy imaging to retest] Is the issue reproducible?
[At that time I was – NB 32] Are you running the latest version?
[YES ] Are all prerequisites that are mentioned inside the manual met?
Description
NINA started to warm the camera after the sequence ended. I decided to rerun the sequence to get more subs and Auto-Focus started running. Not sure why. See the attached screen-shot. Both ‘Warm Camera When Sequence Ends’ and ‘ Auto Focus On Start’ were turned OFF. This was done with the simple Sequencer only.
Running the following
- NINA 1.11 NB 32
- PHD Guide 2 Rel 2.6.9 Dev 3
- TheSkyX Pro
- Windows 10 x64
Steps to Reproduce
Unclear. Set up a sequence run using the simple sequencer only. With “Warm Camera When Sequence Ends” OFF and “Auto Focus On Start” OFF. Its unclear if auto-focus running is a bug but the camera warming needs to be looked into.
Expected behavior
Function as expected
Actual behavior
Camera warned up and I had to re-cool the camera to -10c.
Comments (5)
-
reporter -
reporter On Nightly Build 038 I can’t reproduce this error with the same setup.
-
reporter Build 046 did this once. I can not force the problem. I will try on the next nightly.
-
repo owner - changed status to closed
no updates for a while. assuming this problem is not occuring anymore.
-
repo owner - removed version
Removing version: 1.11 Nightly (automated comment)
- Log in to comment
Here's the log from that night. I did have issues with the Pegasus FocusCube2 and had to unplug the USB cable and plug it back in again. I am not sure what's causing the other errors. Any insight into the above errors would be helpful and also the ASI2600MC Pro warming up bug. I also need to look into issues with my 'Horizon' file. If you want me to do additional testing let me know.
Thx.