AF After file change does not show last filter

This is a cosmetic only issue with 1.11 # 125 (I think - observed 8/20, whatever current then).

The AF After filter change instruction, on the sequence page, appears to intend to show the last filter at the time it invoked. It is blank after it invokes, in this case it was invoked from a prior plate solve with luminance (above the loop/trigger), and inside the loop a smart exposure with Ha.

I believe it should show the prior filter which, different from current, caused invocation.

The actual AF run worked as expected, this is purely a display issue.

‌

Comments (2)