[HDD] Transfer VCD over network using RadHostClient

______________________________________________________________________________________________________________

Hardware Requirements :

• PS2 HDD formatted, with a __.POPS partition, connected to your PC via network

Software Requirements :

• RadHostClient
• uLE
  ______________________________________________________________________________________________________________

1. [PS2 side] If not done yet, configure using uLE your network settings giving your PS2 an IP adress (“Configure uLaunchElf/Network Settings…”). Do not forget to save it – and do not forget the IP adress ;

2. [PS2] Go back to uLE File broswer, then enter host:/ ;

3. [PC side] Launch RadHostClient and set the PS2 IP adress. Once your PS2 is detected over network, you will see “Connected” at the bottom of RadHostClient program ;

4. [PC] Drag & drop your VCDs from his (their) folder(s) to RadHostClient program ;

5. [PS2] Time to refresh : go back to uLE File broswer, then enter host:/ again ;

6. [PS2] Your VCDs should now be visible into uLE. Copy/paste them from host:/ to __.POPS partition ;

7. Done.

______________________________________________________________________________________________________________

Index