- edited description
Problem snapshots
Issue #97
resolved
Hello, according to me something is wrong with the snapshots tool. When I click on the plus sign to make a first snapshot, it is labeled Snapshot 1 (as usual), but I can’t rename it at this point. Then I change exposure and take a second snapshot, now I can rename it to Expo. If I choose snapshot 1, nothing changes. Can’t delete (via the minus sign) that first snapshot.
When I make more snapshots (b&w, saturated, etc.) it’s sluggish to switch between them, if they react at all.
Comments (12)
-
reporter
-
reporter
- edited description
-
repo owner
Could it be something wrong on your side? Everything works here:
https://filebin.net/iquaq437vll2tfs0/Peek_2020-05-27_12-15.mp4?t=jp83z2hg
-
reporter
Perhaps you’re right, I’ll try a bit further (but there is something strange going on, at least here…!).
-
repo owner
@Paul Matthijsse were you seeing some “overlay” error messages before expriencing the problem? If so, then I might have found the culprit…
-
reporter
YES! (Concerning Dehaze filter).
-
reporter
You mean this? It appears since this morning after a fresh build.
-
repo owner
that was the culprit then. I should have fixed it now
-
reporter
Fixed indeed. Grazie signore!
-
reporter
Still a problem left with these snapshots.
- Open a raw or jpg, make a snapshot, call it 'loaded'
- Adapt exposure, make a snapshot, call it ‘expo’
- Adapt white balance (a lot), make a snapshot, call it ‘wb’.
So far, so good.
Now click snapshot expo. The white balance slider goes back to its original position, but the image does not change. Only by changing the wb slider with +1 or -1, the original wb is back.
Related. Click snapshot loaded. The original image appears. Click expo and the adapted expo appears. Click wb, the wb slider is a lot to the right but the image does not change. Again +1 or -1 solves this.
-
repo owner
- changed status to resolved
-
reporter
Thanks, works fine now.
- Log in to comment