- attached Extended Curve Path.png
Draw free curve path point at distance
Issue #259
resolved
There is a pattern construction instruction (Mueller and Son) that tells "... draw neckline and extend by 1 cm".
From the original instruction, unfortunately it is not completely clear if that means to draw a straight line in extension to the curve (like in the example picture) or actually to continue the curved line by a segment of a specific length. Dependent on that there are two different potential procedures:
- Extend the spline path tool to allow to draw (a) free point(s). Need to measure/lock lenght of this segment cause this is a constraint (see above)
- Give the possibility to somehow derive the angle of a line (point at distance and angle) from the spline paths' end curvature (somehow reverse case of issue #233)
Comments (4)
-
reporter -
It means to draw a straight line in extension to the curve. This would be a very beneficial tool.
-
Account Deleted I would like to extend or drop the armhole curve length based on some calculations. I'm able to drop but dont know how to extend the curve.
-
repo owner - changed status to resolved
Resolved issue
#259. Draw free curve path point at distance.→ <<cset 538edde8b55e>>
- Log in to comment