Error in Detail using 'Segment a Simple Curve' tool
Issue #412
resolved
On Ubuntu 14.04 64 bit:
I used the 'Segment a Simple Curve' tool to split a curve. Then created two details, each half of the curve should be in only one detail.
The Detail containing the 1st half of the curve is incorrect. The Detail containing the 2nd half of the curve is correct. See attached image. MyNewPattern2.val file is attached, no measurement file required.
Comments (8)
-
repo owner -
reporter -
reporter - attached MyNewPattern2.val
-
repo owner - changed status to open
Confirm.
-
reporter You're too fast for me! File now uploaded, including image in Draw mode.
-
repo owner No, i am not. If i would, you would see "fixed".
-
repo owner I have found problem, but also want to make test for this case.
-
repo owner - changed status to resolved
Fixed issue
#412. Error in Detail using 'Segment a Simple Curve' tool.→ <<cset 5461aea07461>>
- Log in to comment
Show me the pattern file.