- changed status to resolved
Error: Can't create Seam Allowance after using Union Tool
Issue #521
resolved
Ubuntu 14.04 64-bit Test Build v0.5.0.1285a build rev 01d47c22fd13
In Detail mode, can't add a seam allowance after joining two pieces with Union Tool. The two pieces use the same points.
Comments (9)
-
repo owner -
reporter Not resolved yet.
After the commit for this issue, the Seam Allowance can be created but it is incorrect. It leaves out a point in the path. See the attached video.
-
reporter - attached test_unionTool_seamAllowance.val
-
reporter -
repo owner I see. But this is completely different issue.
-
reporter -
repo owner Or maybe not. :)
-
reporter - changed status to open
This issue was reopened because the Seam Allowance can be created, but it isn't correct. A simple *.val file has been uploaded to use to test this use case.
-
repo owner - changed status to resolved
Fixed issue
#521. Error: Can't create Seam Allowance after using Union Tool.→ <<cset 935a3e9c4aa8>>
- Log in to comment
Resolved issue
#521. Error: Can't create Seam Allowance after using Union Tool.→ <<cset 25672b794b5a>>