Wiki
Clone wikiEspecWeb / Firmware Flash Instructions Headless
Headless Firmware Flash Instructions
For UP2 web controller hardware (mini computer).
- Disconnect power from the web controller hardware via the barrel jack.
-
Plug in the firmware USB drive.
-
Apply power to the web controller. Ensure the Blue Power LED turns on:
-
Wait for the blue power LED to turn off, this should take approximately 5 minutes.
- If after 15 minutes the power LED is not off there is likely a problem and this flash procedure will not work, contact engineering.
- Disconnect power from the web controller hardware via the barrel jack.
-
Remove the Firmware USB drive and plug in the BIOS configuration USB dongle:
-
Apply power to the web controller.
- The system will now automatically configure the bios.
- Wait about 3 minutes. The web controller will reboot (power LED blink off) twice this is normal and can be ignored.
- Remove the BIOS configuration USB dongle.
- Once the web controller is accessible via a computer setup proceed with standard chamber configuration setup.
Document History:
Updated