- changed status to resolved
When starting a sequence with AF set to perform on seq. start, AF runs twice instead of for just the required filter
[x] Is the issue reproducible? [x] Are you running the latest version? [x] Are all prerequisites that are mentioned inside the manual met?
I have my AF configuration set to: - run on start of sequence - run on filter change - run when temp changes 2 degs.
Steps to reproduce:
1) Ensure your event #1 in your sequence is for filter X and the event is enabled but COMPLETE (i.e. 30/30 frames already completed).
2) Ensure your event #2 in your sequence is for filter Y and is NOT complete.
Expected behaviour:
System would skip AF for filter X since no frames are to be captured for event #1 and goes straight to AF for filter Y.
Actual behaviour: System performs AF for filter X and then immediately performs AF for filter Y (it doesn't seem to matter what filter is current in the FW when the sequence is started).
Comments (1)
-
repo owner - Log in to comment
Fix Issue
#201- When starting a sequence with AF set to perform on seq. start, AF runs twice instead of for just the required filter→ <<cset 8bb7f073b2bc>>